[PVE-User] vlan setup at time of host installation

[Michael Cooper]

Hello Guys,

I don't know if this is relevant but I thought I would chime in.

This is one is for Network Bonding in Proxmox -> Nic Bonding in Proxmox 
<https://www.youtube.com/watch?v=auMugO3zsKw>

This one is Bond Nics w/VLan Support in Proxmox 
<https://www.youtube.com/watch?v=nIip66Rzt4I>


I apologize if this is not what you were wanting.

Thanks,

Michael

On 7/16/23 12:44 AM, Timo Veith wrote:
>
>> Am 15.07.2023 um 22:43 schrieb Arjen via pve-user<pve-user at lists.proxmox.com>:
>>
>>
>> Von: Arjen <leesteken+proxmox at pm.me  <mailto:leesteken+proxmox at pm.me>>
>> Betreff: Aw: [PVE-User] vlan setup at time of host installation
>> Datum: 15. Juli 2023 um 22:43:37 MESZ
>> An: Proxmox VE user list <pve-user at lists.proxmox.com  <mailto:pve-user at lists.proxmox.com>>
>>
>>
>> ------- Original Message -------
>> On Saturday, July 15th, 2023 at 22:25, Timo Veith <timo.veith at uni-tuebingen.de  <mailto:timo.veith at uni-tuebingen.de>> wrote:
>>
>>> Dear pve users,
>>>
>>> I am totally new to pve. Is there a recommended way to setup vlans during the installation of a host? I have found some notes about vlans in the documentation but it only describes some sections in /etc/network/interfaces but it doesn’t say when this should be done. In fact I did one of the proposed methods and I can connect to the management ip address in that vlan but I wonder if it was right how I did it. I installed from the iso, configured some ip because I didn’t find any option for using vlans in the installer and then searched through the documentation. I changed the /etc/network/interfaces and did a reboot. Where after I was able to connect to the ip address that I configured. However in the console I can still read „use blabla ip and port 8006“ which is the ip I used during the installation.
>>>
>>> Cheers
>>> Timo
>> Don't panic; you did nothing wrong. The installer is rather simple and only does the basic installation.
>> It's common to setup more complex things (like vlan) after installation. If the Proxmox GUI does not support it, or is not (yet) reachable, you do those things on the Proxmox console.
>> The console welcome message probably takes the IP address from /etc/hosts, which you also need to manually adjust to match the new IP.
>>
>> Best regards
>>
>
> Hello Arjen,
>
> thank you for your reply.
>
> I understand. Do you have some more common examples of cases where you can only configure that after the GUI installation and with the console?
>
> Greetings
> Timo
>
>
>
>
>
>
> _______________________________________________
> pve-user mailing list
> pve-user at lists.proxmox.com
> https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user
-- 
*Michael Cooper*
/Systems Engineer/
Coopfire Services <http://www.coopfire.com>