[PVE-User] 802.3ad Bonding Proxmox 1.4

[Andrew Niemantsverdriet]

I just went in and enabled STP the bridge is now and able to
communicate. It is slow though. Still can't see more than 943Mbits/sec
through the bond0 interface.

# network interface settings
auto lo
iface lo inet loopback

iface eth0 inet manual

iface eth1 inet manual

iface eth2 inet manual

iface eth3 inet manual

iface eth4 inet manual

auto eth5
iface eth5 inet static
	address  192.168.3.4
	netmask  255.255.255.0

auto bond0
iface bond0 inet manual
	slaves eth0 eth1 eth2 eth3 eth4
	bond_miimon 100
	bond_mode 802.3ad

auto vmbr0
iface vmbr0 inet static
	address  192.0.2.6
	netmask  255.255.255.0
	gateway 192.0.2.1
	bridge_ports bond0
	bridge_stp on
	bridge_fd 0

The switch shows 802.3ad partners so that is working however the speed
sucks although that is better than not working.

Any ideas?


On Mon, Nov 9, 2009 at 10:35 PM, Dietmar Maurer <dietmar at proxmox.com> wrote:
>> -----Original Message-----
>> From: pve-user-bounces at pve.proxmox.com [mailto:pve-user-
>> bounces at pve.proxmox.com] On Behalf Of Andrew Niemantsverdriet
>> Sent: Dienstag, 10. November 2009 00:43
>> To: proxmoxve
>> Subject: [PVE-User] 802.3ad Bonding Proxmox 1.4
>>
>> I am testing out Proxmox 1.4 and 802.3ad bonding. I can't join bond0
>> the vmbr0 when that happens the bridge stops working. However when
>> bond0 is no part of the bridge everything works fine.
>
> Do you enabled STP?
>
>> In Proxmox 1.3
>> all I had to do was change in the interfaces file from 802.3ad to 4
>> and it worked. In this version that does not work. How can I make that
>> work again?
>
> We did not changed anything in the networking code.
>
> - Dietmar
>
>



-- 
 _
/-\ ndrew Niemantsverdriet
Academic Computing
(406) 238-7360
Rocky Mountain College
1511 Poly Dr.
Billings MT, 59102