[pve-devel] superseded: [PATCH docs/installer v4 0/9] add early disk and network sanity checks

Michael Köppl m.koeppl at proxmox.com
Tue Jul 15 11:50:22 CEST 2025


Superseded-by:
https://lore.proxmox.com/pve-devel/20250715094021.154914-1-m.koeppl@proxmox.com

On 7/11/25 18:27, Michael Köppl wrote:
> The goal of this series is to add additional sanity checks to the
> auto-installer and the TUI and GUI installers. The following checks were
> added:
> * Btrfs / ZFS RAID: check if the required number of disks is available
> * LVM: check if swapsize < hdsize
> * Duplicate disks in answer file disk selection
> * Networking: check if IPv4 address is valid within subnet (RFC)
> 
> Additionally, the documentation regarding maxroot is adapted to remove
> the maximum maxroot size requirement since there was no check and adding
> a sanity check would have prevented users from installing on setups with
> very small disks even if the installation could have succeeded.
> 
> The disk-related checks aim to close [0], whereas the IPv4 check would
> partially close [1].
> 
> [0] https://bugzilla.proxmox.com/show_bug.cgi?id=5887
> [1] https://bugzilla.proxmox.com/show_bug.cgi?id=5757
> 
> Changes since v3:
> - Rebased on master
> - Moved unit tests for ZfsRaidLevel and BtrfsRaidLevel to
>   proxmox_installer_common::otions
> - Rename check_disks() proxmox_installer_common to check_raid_disks_setup()
> - Move dummy_disk() function for tests into Disk struct
> - Add new patch that unifies error messages regarding disk and RAID
>   setup checks across TUI and GUI (mostly, see comment in 8/8)
> - Use anyhow::Result to handle errors in LVM disk setups (swapsize, ...)
> - Move the refactoring of CidrAddressParseError's Display implementation
>   to an earlier patch instead of rewriting later on
> - Add FIXME to CidrAddressEditView's FormViewGetValue implementation
>   regarding the proper return type that should be used, needs a bigger
>   refactoring
> 
> Changes since v2:
> - Rebased on master
> - Removed maxroot check and instead adapted documentation
> - Remove some changes that were the result of formatting otherwise
>   unchanged lines of code
> - Added patch to improve error handling when checking CIDR address TUI
>   network dialog
> - In installer 7/7, use the limit variable for the check_mask_limit
>   function instead of hardcoded 32
> 
> Changes since v1:
> - Removed rustfmt patch
> - Removed patch that changed check_zfs_raid_config (replaced with patch
>   below)
> - Added patch that moves implementation of RAID setup checks to
>   implementation of ZfsRaidLevel and BtrfsRaidLevel
> - Adapted tests for RAID setup validity
> - Added configured values in GiB to error messages for invalid
>   swapsize and maxroot
> - Changed maximum allowed swapsize to hdsize/8
> - De-duplicated swapsize and maxroot check implementations in
>   autoinstaller utils and common's disk_checks
> - Added patch that adds a check for duplicate disks in answer file disk
>   selection
> - Refactored Display implementation of CidrAddressParseError
> - Simplified Deserialize implementation of CidrAddress
> - Explicitly allow /31 and /32 subnets in CIDR validity check
> 
> Thanks to @Christoph for reviewing the previous versions and his suggestions.
> 
> pve-docs:
> 
> Michael Köppl (1):
>   installation: remove maxroot size requirement and mention default
>     instead
> 
>  pve-installation.adoc | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> 
> pve-installer:
> 
> Michael Köppl (8):
>   auto: add early answer file sanity check for RAID configurations
>   move RAID setup checks to RAID level enum implementations
>   close #5887: add sanity check for LVM swapsize
>   auto: add check for duplicate disks in answer file
>   common: add more descriptive errors for invalid network configs
>   tui: change get_value return type for easier error handling
>   common: add checks for valid subnet mask and IPv4 address within
>     subnet
>   tui, gui: streamline error messages around disk and RAID checks
> 
>  Proxmox/Install.pm                            |  24 ++-
>  proxinstall                                   |  10 +-
>  proxmox-auto-install-assistant/src/main.rs    |   3 +-
>  proxmox-auto-installer/src/utils.rs           |  38 +++-
>  proxmox-auto-installer/tests/parse-answer.rs  |   9 +-
>  .../parse_answer/ipv4_and_subnet_31.json      |  19 ++
>  .../parse_answer/ipv4_and_subnet_31.toml      |  18 ++
>  .../btrfs_raid_single_disk.json               |   3 +
>  .../btrfs_raid_single_disk.toml               |  15 ++
>  .../parse_answer_fail/duplicate_disk.json     |   3 +
>  .../parse_answer_fail/duplicate_disk.toml     |  15 ++
>  .../ipv4_and_subnet_addr_is_network.json      |   3 +
>  .../ipv4_and_subnet_addr_is_network.toml      |  18 ++
>  .../ipv4_and_subnet_mask_33.json              |   3 +
>  .../ipv4_and_subnet_mask_33.toml              |  18 ++
>  .../lvm_swapsize_greater_than_hdsize.json     |   3 +
>  .../lvm_swapsize_greater_than_hdsize.toml     |  16 ++
>  .../zfs_raid_single_disk.json                 |   3 +
>  .../zfs_raid_single_disk.toml                 |  15 ++
>  proxmox-installer-common/src/disk_checks.rs   | 168 +++---------------
>  proxmox-installer-common/src/options.rs       | 147 +++++++++++++++
>  proxmox-installer-common/src/utils.rs         |  85 +++++++--
>  proxmox-tui-installer/Cargo.toml              |   1 +
>  proxmox-tui-installer/src/main.rs             |   8 +-
>  proxmox-tui-installer/src/views/bootdisk.rs   |  17 +-
>  proxmox-tui-installer/src/views/mod.rs        |   9 +-
>  26 files changed, 488 insertions(+), 183 deletions(-)
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer/ipv4_and_subnet_31.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer/ipv4_and_subnet_31.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/btrfs_raid_single_disk.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/btrfs_raid_single_disk.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/duplicate_disk.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/duplicate_disk.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/ipv4_and_subnet_addr_is_network.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/ipv4_and_subnet_addr_is_network.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/ipv4_and_subnet_mask_33.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/ipv4_and_subnet_mask_33.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/lvm_swapsize_greater_than_hdsize.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/lvm_swapsize_greater_than_hdsize.toml
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/zfs_raid_single_disk.json
>  create mode 100644 proxmox-auto-installer/tests/resources/parse_answer_fail/zfs_raid_single_disk.toml
> 
> 
> Summary over all repositories:
>   27 files changed, 491 insertions(+), 184 deletions(-)
> 





More information about the pve-devel mailing list