[pve-devel] applied: [PATCH docs 1/2] remove 4th section and fix typos

[Thomas Lamprecht]

On 11/13/18 3:18 PM, Dominik Csapak wrote:
> manpages cannot have a 4th section, replace them with
> titles
> 
> Signed-off-by: Dominik Csapak <d.csapak at proxmox.com>
> ---
>  qm-pci-passthrough.adoc | 17 +++++++----------
>  1 file changed, 7 insertions(+), 10 deletions(-)
> 
> diff --git a/qm-pci-passthrough.adoc b/qm-pci-passthrough.adoc
> index b85bfb6..6a70469 100644
> --- a/qm-pci-passthrough.adoc
> +++ b/qm-pci-passthrough.adoc
> @@ -40,11 +40,10 @@ Once you ensured that your hardware supports passthrough, you will need to do
>  some configuration to enable PCI(e) passthrough.
>  
>  
> -IOMMU
> -+++++
> +.IOMMU
>  
>  The IOMMU has to be activated on the kernel commandline. The easiest way is to
> -enable trough grub. Edit `'/etc/default/grub'' and add the following to th
> +enable trough grub. Edit `'/etc/default/grub'' and add the following to the
>  'GRUB_CMDLINE_LINUX_DEFAULT' variable:
>  
>  * for Intel CPUs:
> @@ -58,14 +57,14 @@ enable trough grub. Edit `'/etc/default/grub'' and add the following to th
>   amd_iommu=on
>  ----
>  
> +[[qm_pci_passthrough_update_grub]]
>  To bring this change in effect, make sure you run:
>  
>  ----
>  # update-grub
>  ----
>  
> -Kernel Modules
> -++++++++++++++
> +.Kernel Modules
>  
>  You have to make sure the following modules are loaded. This can be achieved by
>  adding them to `'/etc/modules''
> @@ -85,8 +84,7 @@ After changing anything modules related, you need to refresh your
>  # update-initramfs -u -k all
>  ----
>  
> -Finish Configuration
> -++++++++++++++++++++
> +.Finish Configuration
>  
>  Finally reboot to bring the changes into effect and check that it is indeed
>  enabled.
> @@ -198,8 +196,7 @@ Some PCI(e) devices need this disabled.
>  * *romfile=<path>*, is an optional path to a ROM file for the device to use.
>  This is a relative path under */usr/share/kvm/*.
>  
> -Example
> -+++++++
> +.Example
>  
>  An example of PCIe passthrough with a GPU set to primary:
>  
> @@ -261,7 +258,7 @@ the fly. For example, to setup 4 VFs on device 0000:01:00.0 execute:
>  ----
>  +
>  To make this change persistent you can use the `sysfsutils` Debian package.
> -After installation configure it via */etc/sysfs.conf* or a `FILE.conf' inf
> +After installation configure it via */etc/sysfs.conf* or a `FILE.conf' in
>  */etc/sysfs.d/*.
>  
>  VM Configuration
> 

applied