[PVE-User] Question about best way to replace boot disk of a proxmox + ceph node

Ralf Storm ralf.storm at konzept-is.de
Fri Jul 9 12:16:38 CEST 2021


Hello Christoph,

please read the documentation about removing/replacing a Node carefully 
- you may not reinstall it with the same IP and/or Name as this will 
crash your whole cluster!

I would use the node6 to move the ceph-part and then reinstall the node 
with new ip and name.

For the boot disks we use 2 or 3 mirrored zfs disks to be sure...


Best regards

Ralf


Am 09.07.2021 um 11:43 schrieb Christoph Weber:
> Hi everybody,
>
> we have one proxmox node  (node3) with ceph where the boot disk is beginning to fail (In fact we already experienced some defective system libraries which led to kernel panic on boot until we were able to determine the affected library to be replaced with a working copy).
>
> We see two possible ways:
> a) clone the partially defective disk to a new ssd which would keep all configuration, but might also copy defective files
> b) install a fresh copy of proxmox 6.4  with two subvariants:
>     b1) only configure the same network interface address and name and join the proxmox and ceph cluster when the node has booted up
>     b2) copy network configuration and /etc/ceph folder from defective node to the new disk before booting - and then join the proxmox cluster. In this case the question is, if there are more files to be copied like /etc/corosync?
>
> Method b1 seems to be the most safe to me, but I'm not 100% sure if it might be a problem when we cluster join the node3 again with the same name and ip address as it was.
> Would we have to prepare ceph or proxmox for this? Remove the node3 from ceph and/or proxmox before we re-join it?
>
> Additional Bonus: We have a fresh node (node6) without disks set up - we might move the ceph disks from the node3 to the new node6 before we replace the bootdisk.
>
> Any opinions/suggestions would be greatly appreciated
>



More information about the pve-user mailing list