[PVE-User] UEFI - Proxmox

Arjen van Weelden arjenvanweelden at gmail.com
Thu Mar 21 17:54:40 CET 2019


I've noticed that if your system boots in UEFI mode and you choose ZFS
during installation, Proxmox installs ZFS and an UEFI boot partition. This
does then not boot afterwards, without warnings of errors.

I believe that Proxmox does not support ZFS in combination with UEFI. You
have to use ext4/lvm instead, or boot in BIOS mode.

Hope this helps, Arjen

On Thu, Mar 21, 2019, 16:16 Alain Péan <alain.pean at c2n.upsaclay.fr> wrote:

> Le 21/03/2019 à 09:16, lord_Niedzwiedz a écrit :
> > A heave only UEFI bios in serwer.
> >
> > How I make start Proxmox ?
> >
> > I install it, but Proxmox not start  ;-/
> >
> > Any ideas ?
>
> I am using UEFI with newer servers. It works without problem. For
> example, I have the boot/efi partition :
> # cat /etc/fstab
> # <file system> <mount point> <type> <options> <dump> <pass>
> /dev/pve/root / ext4 errors=remount-ro 0 1
> UUID=CF7B-601B /boot/efi vfat defaults 0 1
> /dev/pve/swap none swap sw 0 0
> proc /proc proc defaults 0 0
>
> With usual servers (I have Dell ones), you have the choice in the BIOS
> between lagacy BIOS or UEFI. Just choose UEFI, then boot with the last
> proxmox ve iso. If you don't have the choice, only UEEFI, just boot the
> iso and proceed with the installation, which is largely automated.
>
> Alain
>
> --
> Administrateur Système/Réseau
> C2N Centre de Nanosciences et Nanotechnologies (UMR 9001)
> Boulevard Thomas Gobert (ex Avenue de La Vauve), 91920 Palaiseau
> Tel : 01-70-27-06-88 Bureau A255
>
> _______________________________________________
> pve-user mailing list
> pve-user at pve.proxmox.com
> https://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
>


More information about the pve-user mailing list