[PVE-User] sbin/unconfigured.sh

Fabian Gr├╝nbichler f.gruenbichler at proxmox.com
Fri May 19 13:46:38 CEST 2017


On Fri, May 19, 2017 at 10:27:20AM +0100, Steve wrote:
> If I type xinit it says /bin/sh: xinit: not found
> 
> I am the author of easy2boot which is a USB multiboot tool to allow people
> to boot from 100's of different ISOs (or images) all from one USB stick.
> I have been asked by a user to get proxmox 4 working.
> 3.2 works because I can run the unconfigured.sh from the command line
> 
> http://rmprepusb.blogspot.co.uk/2014/03/add-proxmox-isos-to-easy2boot.html
> http://www.easy2boot.com
> 
> I tried setting proxdebug and  root=/dev/sdb1  or lvm2root=/dev/sdb1 to get
> it to mount the FAT32 partition to /mnt. I do not need to manually use any
> mount commands, it just automatically runs init but this causes an early
> error message of
> mount: mounting /dev/sdb1 on /mnt failed: Invalid argument
> but if I use the mount command I can see that /mnt is present as a vfat
> /dev/sdb1
> If I press CTRL+D to continue, it fails in the exact same place with
> Installation aborted - unable to continue.
> Note that this is not using my script at all, just the original init script
> - I have not broken into the boot process because it picks up the lvm2root
> parameter.
> 
> I am so *near*, yet I just cannot get the unconfigured.sh script to run in
> this way...
> 
> thanks for your help.
> Steve

I just did a quick test run using Grub:

loopback test PATHTOISO
linux (test)/boot/linux26 proxdebug ramdisk_size=16777216 rw
initrd (test)/boot/initrd.img
boot

drops me into the initrd debug shell

if I do the following (major/minor depend on your disk configuration,
  check /sys/class/block/XXX/dev where XXX is your usb partition where
  the iso is)

mknod /tmp/usbdev b MAJOR MINOR
mkdir /tmp/usbmnt
mount /tmp/usbdev /tmp/usbmnt
mount /tmp/usbmnt/PATHTOISO /mnt

followed by lines 294ff of the init script launch the graphical
installer (although the resolution is messed up - probably because I did
not bother to change any of the graphic stuff in Grub), and I am able to
complete the installation..

so I think it must be something in your environment / setup.

(note that there are TWO debug shells, one in the initrd with very
limited commands, and one in the installer environment with access to a
lot more tools - a quick test is to run something like "lsblk", since
that only exists in the latter environment ;). maybe your switch to the
installer environment did not work, and you are still in the initrd
shell? that would explain why you can't execute "xinit")



More information about the pve-user mailing list