[PVE-User] VLANs

[Uwe Sauter]

I have a setup where I don't use Proxmox own VLAN management but have one bridge per VLAN that I use:

/etc/network/interfaces
###
auto lo
iface lo inet loopback

auto eth0
iface eth0 inet static
        address 192.168.253.200
        netmask 255.255.255.0
        gateway 192.168.253.254

auto eth0.101
iface eth0.101 inet manual

auto eth0.102
iface eth0.102 inet manual

auto vmbr101
iface vmbr101 inet manual
        bridge_ports eth0.101
        bridge_stp off
        bridge_fd 0

auto vmbr102
iface vmbr102 inet manual
        bridge_ports eth0.102
        bridge_stp off
        bridge_fd 0

###

eth0 is used for access to the Proxmox host.
VLAN 101 and 102 are used for VMs.
Ths switch port is configured for VLAN 100 untagged (native) and VLAN 101 and 102 tagged.

This gives you two VLANs that can be assigned separately to you VMs.

If you need more details, keep asking.


Regards,

	Uwe

Am 28.02.2017 um 16:32 schrieb Daniel:
> Hi there,
> 
> i wanted to create a VLAN based on my Bonding interface.
> I was looking in  the wiki (https://pve.proxmox.com/wiki/Category:HOWTO) but I didn’t find any ideas. Just old Versions seems to be documented.
> 
> Could you tell me who I can setup an VLAN without an IP Assigned to that interface and how can I add this later on a Container/VM.
> Just change vmbr0 interface to the VLAN interface?
> 
> --
> Grüsse
> 
> Daniel
> _______________________________________________
> pve-user mailing list
> pve-user at pve.proxmox.com
> http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
>