[PVE-User] Simulate disconnected network cable

[Mark Ehle]

Thanks, Vassilis - however, I am not looking to have the VM automatically
take over for the hardware firewall at this point. Like I said, in
Virtualbox on the network settings page of the VM settings, there is a
checkbox to "unplug" the virtual network cable to a virtual interface. Is
there a way to do that with Proxmox?

Mark

On Mon, May 7, 2012 at 3:59 AM, Vassilis V. <Bigraccoon at gmx.net> wrote:

>
>
> Mark Ehle wrote on 06.05.2012 19:37:
> > When I make changes to the
> > physical machine I would like to update the config on the virtual
> > machine, too, however, I can't bring the firewall VM up on the network
> > because there is already a real machine on the network with the same IP
> > addresses in use. Is there a way around this?
>
>
> Hello Mark,
>
> if I understand your question correctly, I think the CARP feature in
> fsense is what you are looking for.
>
> http://doc.pfsense.org/index.php/Configuring_pfSense_Hardware_Redundancy_%28CARP%29
>
> Regards,
> Vassilis
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.proxmox.com/pipermail/pve-user/attachments/20120507/f7e2d2e3/attachment.htm>