[PVE-User] Problem proxmox 2.0 to forward vmbr1 to eth0, eth1, eth2 VM

Maykel Franco Hernández maykel at maykel.sytes.net
Mon Mar 26 12:52:09 CEST 2012


El 2012-03-26 11:51, Giuliano Natali (Diaolin) escribió: 

maykel at maykel.sytes.netwrote:
>> Hi Flavio, thanks for your response.
The idea was to connect: vmbr0 --> LAN vmbr1 --> LAN vmbr2 --> WAN vmbr3
--> WAN But even with the same range of ips in vmbr1, vmbr2 and vmbr3,
if there is a cable not connected vmbr3 vmbr2 and should not answer to
ping. Do not you think?
> In this case is better to create all the
bridges withouth ip address and then
> create a bond...
> You'll find
it in System
> Diaolin
> pve-user mailing
pve-user at pve.proxmox.comhttp://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user

not be so, because if you do not install and configure Proxmox 3
network cards with different ips although they are in the same network,
if you make a pingto each card you answer each network card.

contrast, in Proxmox 2.0 is not so, when pinging or vmbr3 vmbr2
vmbr1answer you and that can not be ...

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.proxmox.com/pipermail/pve-user/attachments/20120326/5d93fef7/attachment.htm>

More information about the pve-user mailing list