[PVE-User] How to activate eth1?

[Giuliano Natali]

On Ven, ottobre 29, 2010, 7:18 am, Bruce B wrote:
> Hi Everyone,
>
> Just learning Proxmox here. I can't seem to get the network running
> properly. Documentation is kind of incomplete on the wiki:
>
>
>  Interface Active Ports/Slaves Autostart IP Address Subnet Mask Gateway
>
>  vmbr0yeseth0 10.100.100.130255.255.255.010.100.100.1 vmbr1yeseth1
> 10.100.100.131255.255.255.0
>
> Seems like I am missing the Gateway in vmbr1 and there is no place for it
> when I edit it. So, I assigned it to a VM but I don't see the IP picked
> up.
>
> Furthermore, for redundancy reasons should I bond eth0 and eth1 or should
> I
> keep them as separate connections come in and then assign each VM both
> connections?
>


Use bonding but avoid to use the same network address on the two eth?


Assign the address (one) to the bond0......


Diaolin


> Thanks
> _______________________________________________
> pve-user mailing list
> pve-user at pve.proxmox.com
> http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
>


-- 
l’à piangiù par tut el dì, somenàndo ‘ntorn le làgreme
pò da sót gió ‘n vèrs la val vèn su un con na manàra
el se rampega pan pian, pò ‘l se ferma e ‘l tira ‘l fià
el se ‘mpiza su na ghèba, gió doi crèpi e tàse tut

Diaolin