[PVE-User] vmbr0 issues with openvz container

[Dietmar Maurer]

Any you use the pve standard kernel (not a self compiled one)?

- Dietmar

> -----Original Message-----
> From: pve-user-bounces at pve.proxmox.com [mailto:pve-user-
> bounces at pve.proxmox.com] On Behalf Of Pongracz Istvan
> Sent: Freitag, 21. November 2008 22:01
> To: pve-user at pve.proxmox.com
> Subject: [PVE-User] vmbr0 issues with openvz container
> 
> Hi,
> 
> I found something strange with the bridged network with openvz
> container.
> I cannot reach the network from the VE, without issuing a 'ifconfig
> veth101.0 0' manually.
> 
> Details:
> I have a vmbr0 -> eth0 -> LAN configuration.
> I added 3 KVM machines to the vmbr0 bridge. They can see to each other
> and they can reach the LAN/internet.
> After I added 2 openvz (pub1, pub2) VEs with bridged networking
> (vmbr0).
> I setup the IP address and route of pub2 and stop/start it.
> By default (without any hack or finetuning) it seems pub1/pub2 cannot
> reach the network.
> I have to issue the following command manually: ifconfig veth101.0 0 to
> get it working.
> 
> I can reproduce it (I already did it several times before I wrote this
> mail).
> 
> My question is, this kind of operation is normal or I missed something?
> Does anybody expect this kind of problem?
> 
> I will check the PVE code to see, what happens in that level......
> 
> Regards,
> István
> 
> 
> --
> BSA. Mert megérdemlitek.
> Open Source. Mert megérdemlem.
> --
> BSA. They value it.
> Open Source. The value. It.
> --
> http://www.startit.hu
> http://www.osbusiness.hu
> 
> _______________________________________________
> pve-user mailing list
> pve-user at pve.proxmox.com
> http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user